Koz Ross on Nostr: Some folks might remember my earlier #Resin3DPrinting experiments involving printed ...

Some folks might remember my earlier #Resin3DPrinting experiments involving printed bearings. I ended up not finishing those due to repeated failures (caused by bad resin, as it turned out). I ended up changing the resin, but life got the better of me, as usual.

However, I had another chance to do a dimensional accuracy test: a replacement keycap. So, here goes! The images are post-wash and cure, but pre-any-processing. The dimple was due to a resin bubble.

1/?

#3DPrinting

nprofile1qy2hwumn8ghj7un9d3shjtnyd968gmewwp6kyqpq2atwfrq4rfv7fqara6gzsgrgj7k8ngewzl5nzs46agwyxzh0e25qvkksy3 (nprofile…ksy3)