Dennis Stephens 🇺🇸 🇫🇮 on Nostr: Been having leveling issues so made this little line test. Did the manual leveling ...

Been having leveling issues so made this little line test. Did the manual leveling and then the measuring step. First print the left side is the table was squishing out the PLA too much so I dropped that side down a tiny bit. Printer the line test again and was better but still a bit high. Adjusted the left side down a bit again and am printing the test a third time. So looks pretty good. Now that it's on the left, it still looks a bit too high. Will adjust again.