Y⃒̸̷̝̜̙ͥͥͥngmar on Nostr: Vertical shaft didn't wanna come out because the drawing I have is different from the ...

Vertical shaft didn't wanna come out because the drawing I have is different from the tractor. In the end I had to pry off a weird bottom cap and found two circlips inside, while the drawing had one on top that I don't have.

After that the shaft came out, I replaced the bottom bearing, a very worn thrust bearing and the steering seal.

Quite a bit of gunk in here to clean. And the bearings were due.

#DIY #Tractor #Repair #Iseki #Mechanic #Circlip #Bearing #Homestead